Listing of sample programs in this package:

BL2000_AD.c
	This program demonstrates how to use the A/D low level driver.
EXTIO_RAM.c
	Connect an external RAM to the Rabbit 2000 via the External I/O interface
GetLine.c
	This program implements a function which will continue to receive characters
	from serial port B until a Carriage Return character is received.
LCD.c
	Connect an LCD to a Rabbit 2000 via a parallel port in 4 bit mode or the
	External I/O interface in 8 bit mode
LowFreq.c
	Measure a low frequency input on PE4 using interrupts
LowFreq.c
	Similar to LowFreq but compatible with costatements
LowPower.c
	Run the Rabbit 2000 with the least amount power possible:
	1) run the CPU from the 32 KHz crystal
	2) turn off the high frequency crystal oscillator
	3) run from RAM
	4) insure that internal I/O instructions do not use CS0
MeasFreq.c
	This program will measure the input frequency applied to the interrupt
	inputs (PE4,PE5) of the Rabbit 2000 microprocessor.  It will work up to
	about 100KHz on the RCM2020 with an 18MHz crystal.
MeasPW.c
	This program will measure the pulse width of an input signal applied to the
	interrupt inputs (PE4,PE5) of the Rabbit 2000 microprocessor.
OP6100.c
	This program interfaces an RCM2000 module to a Keypad and LCD using the
	external I/O capability of the Rabbit 2000.
Pwm.c
	Creates a fixed frequency PWM output on PE7 using Timer B
Pwm2.c
	Creates two independant PWM signals on PE6 & PE7 using Timer B and Timer A1
RTC.c
	One method of setting the Real Time Clock
RTC_SLEEPY.c
	Use the RTC wo wake up the Rabbit 2000 from its sleepy mode
SERIALEXA.C
	This program directs all of the data from a serial port to a TCP port and vice versa.
SPI_A2D.c
	This program will set up and read an LTC1294 12 bit A/D convertor via SPI.
TIMERBVFO.C
	Uses Timer B to set up a periodic interrupt.
VFO.c
	Create a periodic short pulse via a Timer A periodic interrupt
WATDOGDIS.c
	An assembly language which disables the Watch Dog timer
