Release Notes Part No. 93000460 Digi Device Discovery Version 1.7.22.0, 9/20/2016 Software Part No. 40002256 CONTENTS 1. Introduction 2. Supported Products 3. Supported Operating Systems 4. Known Limitations 5. System Requirements 6. History 1. INTRODUCTION This application allows users to find, configure, and launch the configuration and management web interface for the products listed below. 2. SUPPORTED PRODUCTS Digi One Family Digi PortServer TS Family Digi Connect Family Digi ConnectPort Family Digi CM Family Digi Passport Family 3. SUPPORTED OPERATING SYSTEMS Microsoft Windows XP Microsoft Windows Vista Microsoft Windows 7 Microsoft Windows 8 Microsoft Windows 8.1 Microsoft Windows 10 Microsoft Windows Server 2003 Microsoft Windows Server 2008 Microsoft Windows Server 2008 R2 Microsoft Windows Server 2012 Microsoft Windows Server 2012 R2 Microsoft Windows Server 2016 4. KNOWN LIMITATIONS Please update the firmware on your device to the latest version before using this software. Earlier firmware versions may result in the device not showing up in the Device Network list. The application uses multicast to communicate with devices. Anything that interferes with multicast will make the application inoperable. Examples of known conflicts: - Having a firewall between (or on) your PC and the target device. - Having a router or other network hardware between your PC and the target device when the network hardware does not allow multicast traffic. - Running over a VPN or dial up connection that does not support multicast traffic. 5. SYSTEM REQUIREMENTS You might need to apply a Service Pack or install a newer version of Internet Explorer if you are planning to run this application on older Microsoft operating systems. 6. HISTORY Version 1.7.22.0, 09/20/2016 (Rev. H) Release Notes UPDATE -------------------------------------------- o This release (H) has now been tested for all of the above Microsoft operating systems INCLUDING WINDOWS 10. Version 1.7.22.0, 4/27/2012 (Rev. H) -------------------------------------------- o Fixed: A large number of devices on the network may cause the discovery tool to crash. Version 1.6.19.0, 11/23/2004 (Interim) -------------------------------------------- o Added command to telnet to command line interface. o Fixed: Under certain conditions the application failed with error -2 after changing IP settings. o Fixed: Under certain conditions the default gateway was not displayed properly. Version 1.5.17.0, 03/24/2004 (Rev. F) -------------------------------------------- o Added main dialog resizing. o Improved: No reboot required when changing the IP address from 0.0.0.0. o Fixed: Under certain conditions the reboot dialog was hanging. o Fixed: Selecting 'Reboot Device' or 'Configure Network Settings' without selecting a device first could terminate the program. Version 1.4.15.0, 01/22/2004 (Rev. E) -------------------------------------------- o Fixed intermittent application crash. o Improved IP settings validation. Version 1.3.13.0, 09/27/2003 (Rev. D) -------------------------------------------- o Added status bar. o Several minor bugfixes and enhancements. Version 1.2.9.0, 06/26/2003 (Rev. C) -------------------------------------------- o New user interface for easy device configuration. o Several enhancements in the discovery code, including ability to find not properly configured devices. o Support of systems with more than one network adapter. Version 1.1.3.0, 03/17/2003 (Rev. B) -------------------------------------------- o Changed discovery timeout from 120 to 30 seconds to fix a condition in which the application would appear to be hung when trying to contact devices with bad network settings. Version 1.0.2.0, 09/17/2003 (Rev. A1) -------------------------------------------- o Initial release.